Optics ready plates for Walther PDP 1.0

This collection contains optic plates for the Walther PDP 1.0. The plate goes into the factory optic cut of the slide and takes the red dot on top. Every plate is made for one footprint or a group of footprints, so you choose it by the footprint of your red dot. For the Walther PDP Compact 1.0, see Optics ready plates for Walther PDP Compact 1.0.

Footprints for the Walther PDP 1.0

• Trijicon RMR: a plate from 2BME.
• Docter: a plate from 2BME.
• Aimpoint Acro: a plate from 2BME.
• Holosun 509T: a plate from 2BME.

Material

2BME makes its plates from aluminium.

Installation

Remove the cover plate from the optic cut, put the plate in and screw the red dot onto it. Use threadlocker on every screw. No milling and no gunsmith are needed.

All plates at a glance

Which red dot for which footprint

• Trijicon RMR: for example the Holosun 407C, 507C and 508T, Olight Osight and Vector Optics Frenzy-X. See Red dots with Trijicon RMR footprint.
• Docter: also called Vortex Venom or Noblex, for example the Vector Optics Frenzy 1x17x24 and Frenzy-X 1x20x28. See Red dots with Docter footprint.
• Aimpoint Acro: enclosed red dots such as the Steiner MPS. See Red dots with Aimpoint Acro footprint.
• Holosun 509T: the enclosed Holosun 509T.

For all plates of this brand, see Optics ready plates for Walther models.

Frequently asked questions

Can I install an optic plate on my Walther PDP 1.0 at home?

Yes. You need no gunsmith and no milling.

1. Remove the cover plate from the optic cut.
2. Screw the optic plate into the cut.
3. Screw the red dot onto the plate.

Put a drop of threadlocker on every screw.

Which red dots will fit my Walther PDP 1.0?

It depends on the plate you choose. For the Walther PDP 1.0 we have plates for the Trijicon RMR, Docter, Aimpoint Acro and Holosun 509T footprints. Choose your red dot, find its footprint in the specifications and take the plate with the same footprint.