Optics ready plates for Smith & Wesson models

This collection contains products for Smith & Wesson pistols with a factory optic cut:

• An Outer Impact type S plate for the M&P Shield Plus Optics Ready. It fits red dots with the Shield RMSc, Leupold DPP or Holosun K-series footprint. See Optics ready plates for Smith & Wesson M&P Shield Plus Optics Ready.
• Spare screws for the M&P Shield Plus Optics Ready plates.
• The Holosun SCS MP2, a red dot that fits the M&P M2.0 full size directly, without a plate. It fits the 9 mm and .40 S&W versions. It does not fit the M&P 1.0 or the Shield models.

Installation

Remove the factory cover plate from the optic cut. Screw the optic plate into its place, then screw the red dot onto the plate. No milling is needed and you can do it yourself. Threadlocker on the screws is recommended.

Related collections

For Smith & Wesson pistols and revolvers without an optic cut, see Red dot mounts for Smith & Wesson models. For iron sights, see Sights for Smith & Wesson models.

Frequently asked questions

Can I install an optic plate on my M&P Shield Plus at home?

Yes. You need no gunsmith and no milling.

1. Remove the cover plate from the optic cut.
2. Screw the optic plate into the cut.
3. Screw the red dot onto the plate.

Put a drop of threadlocker on every screw.

Which red dots will fit my M&P Shield Plus?

Red dots with the Shield RMSc, Leupold DPP or Holosun K-series footprint. The Outer Impact type S plate takes all three.

Does the Holosun SCS MP2 fit my M&P Shield?

No. It fits only the M&P M2.0 full size in 9 mm and .40 S&W, directly in the optic cut.